I would like to introduce myself my name is Marty. I have been working on this project for the last couple years. This truck was supposed to be a daily driver. I purchased a Sonoma GT so I could build it to drive. However with all projects they sometime start with good intentions and then end up on a completely different path.
Currently the truck is almost ready for paint. The chassis has been set at 4.75 in the rear and 4.25 in the front at it's lowest point. Front Suspension is by Air Ride and the rear suspension was hand fabricated by Dave at Competition Fabrication ( http://www.compfab.com ) .
The first rendering was done by Bob Thrash at Rad Rides by Troy and the second rendering was done by Carter Hickman.
Build Highlights
* Chevy V6 Bowtie Block 4 Bolt Nodular Caps
* Crower Billet Crankshaft,Oliver Rods w/ JE Pistons
* Pontiac Racing Heads w/ Jesel Valve Train
* Hogan Intake Manifold w/ Wilson Throttle Body
* Precision Turbo's w/ Innovative Waste Gates
* 321 Stainless TT Headers w/Stainless Works Exhaust
* Billet Specialties Serpentine Pulley System
* 4L80E Transmission
* Aeromotive Fuel System
* Big Stuff 3 Ignition w/ MSD Ignition
* Currie Aluminum 9" w/ Aluminum Third Member
* Parralel 4 Bar w/ Air Ride Shock Wave Shocks
* Bell Tech 2" Drop Spindle's & Bell Tech Sway Bar
* Air Ride Upper & Lower Control Arm w/Shock Waves
* Air Ride Suspension "Pro-Ride" System
* 14" Wilwood Brakes Front and Rear
* Dual Master Cylnder with remote Bias in cab Control
* Billet Specialties "SLG 20" Soft Lip Wheels,
* BFG KDW II Tires - 295 45 20 rear & 235 40 18 front
* Fiberglass Front Bumper (modified to allow for air intake for the turbochargers)
* Factory Ground Effect remade in Fiberglass
* Core Support Modified to accept Custom Radiator, Intercooler and A/C Condensor
* Billet Hood Hinges
* Harwood Cowl Induction Hood
* Smoothed Firewall and Hand fabricated Inner Fenders
* "A" Pillar modified to match Fender Lines
* Bed Sides Narrowed to match cab width
* Shaved Door handles, tailgate handle and gas door
* 8 Point Roll Cage
* Sheet Metal Dash Conversion
* Recovered Factory Interior in Viper Leather and Suede
* Carbon Fiber Dash Surround, Center Consule Cover and Shifter Knob
* Autometer Gauges
* American Auto Wire Harness
Fabrication by Comp Fab
There are so many other mods that I can't even list them all.
here are a few pics.
Carter Hickman Design digitalpaint@hokdigitalpaintbooth.com
